User's Manual

15
2
1. Route the High Cable (53) through the center
bracket on the Top Frame (8).
Attach a Pulley (42) and two Cable Guides (52)
t
o the center bracket on the Top Frame (8) with
an M10 x 50mm Bolt (58), two M10 Washers
(
73), and an M10 Locknut (68).
Make sure that the Cable Guides (52) are
holding the High Cable (53) in the groove of
the Pulley (42).
21
22. Route the High Cable (53) through the rear
bracket on the Top Frame (8).
Attach a Pulley (42) and two Cable Guides (52)
to the rear bracket on the Top Frame (8) with an
M10 x 50mm Bolt (58), two M10 Washers (73),
and an M10 Locknut (68).
Make sure that the Cable Guides (52) are
holding the High Cable (53) in the groove of
the Pulley (42).
Pull the High Cable (53) downward between the
center and rear brackets on the Top Frame (8)
so that there is slack in the High Cable. The
slack will be used in step 24.
22
23. Thread a 1/2" Nut (84) all the way onto the High
Cable (53).
Place a 26mm Washer (77) and a 13mm
Washer (78) on top of the Weight Selector (7).
Tighten the High Cable (53) three quarters of
the way into the Weight Selector (7). Then,
tighten the 1/2" Nut (84) against the 13mm
Washer (78).
23
68
73
73
53
5
8
5
2
42
8
68
73
73
58
52
42
52
8
53
53
84
78
77
7
5
2