User's Manual

14
1
8. Route the Arm Cable (51) over a Pulley (42).
Attach the Pulley (42) and two Cable Guides
(52) to the left U-bracket (22) on the Upright (5)
w
ith an M10 x 50mm Bolt (58), two M10
Washers (73), and an M10 Locknut (68).
Make sure that the Cable Guides (52) are
holding the Arm Cable (51) in the groove of
the Pulley (42).
18
19. Apply grease to an M10 x 35mm Bolt (59).
Attach the end of the Arm Cable (51) to the Left
Arm (12) with the M10 x 35mm Bolt (59), an
M10 Washer (73), and an M10 Locknut (68).
Do not overtighten the M10 Locknut (68).
The end of the Arm Cable (51) must pivot
easily.
19
20. See the CABLE DIAGRAM on page 26 and
identify the High Cable (53).
Route the High Cable (53) over a Pulley (42).
Attach the Pulley (42) and two Round Cable
Guides (36) to the front bracket on the Top
Frame (8) with an M10 x 50mm Bolt (58), two
M10 Washers (73), and an M10 Locknut (68).
Make sure that the Round Cable Guides (36)
are holding the High Cable (53) in the groove
of the Pulley (42).
Route the High Cable (53) through the Arm
Frame (9) and through the hole in the Upright
(5).
20
58
42
51
51
59
12
52
52
73
73
22
68
68
68
36
36
53
42
73
73
58
8
9
5
5
73
Grease