User's Manual

13
1
5. See the CABLE DIAGRAM on page 26 and
identify the Arm Cable (51).
Apply grease to an M10 x 35mm Bolt (59).
Attach the end of the Arm Cable (51) to the
R
ight Arm (13) with the M10 x 35mm Bolt (59),
an M10 Washer (73), and an M10 Locknut (68).
Do not overtighten the M10 Locknut (68).
The end of the Arm Cable (51) must pivot
easily.
15
73
68
59
13
5
1
17. Route the Arm Cable (51) under a Pulley (42).
Attach the Pulley (42) and two Cable Guides
(52) to one end of the Double U-bracket (24)
with an M10 x 50mm Bolt (58), two M10
Washers (73), and an M10 Locknut (68).
Make sure that the Cable Guides (52) are
holding the Arm Cable (51) in the groove of
the Pulley (42).
17
16. Route the Arm Cable (51) over a Pulley (42).
Attach the Pulley (42) and two Cable Guides
(52) to the right U-bracket (22) on the Upright
(5) with an M10 x 50mm Bolt (58), two M10
Washers (73), and an M10 Locknut (68).
See the inset drawing. Make sure that the
Cable Guides (52) are holding the Arm Cable
(51) in the groove of the Pulley (42).
16
42
42
51
52
52
58
24
73
73
68
52
51
68
73
58
5
52
22
52
52
51
42
Grease