User's Manual

5
Before beginning assembly, carefully read the
following information and instructions:
Assembly requires two people.
Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
Tighten all parts as you assemble them, unless
instructed to do otherwise.
As you assemble the weight system, make sure
all parts are oriented as shown in the drawings.
For help identifying small parts, use the PART
IDENTIFICATION CHART in the centre of the
manual.
The following tools (not included) are required
for assembly:
Two adjustable spanners
One rubber mallet
One standard screwdriver
One Phillips screwdriver
Lubricant, such as grease or petroleum jelly,
and soapy water.
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end span-
ners, or a set of ratchet spanners.
Make Things Easier for Yourself
Everything in this manual is designed to ensure
that the weight system can be assembled suc-
cessfully by anyone. However, it is important to
realise that the versatile weight system has
many parts and that the assembly process will
take time. Most people find that by setting aside
plenty of time, assembly will go smoothly.
ASSEMBLY
1.
Press two 45mm Square Inner Caps (42) into the
ends of the Base (1).
Attach four Plastic Feet (53) to the Base (1) with
four M4 x 25mm Screws (56) and four M4
Washers (92).
Attach a Wheel (31) to the outside of the Base (1)
with an M12 x 105mm Bolt (81), three M12
Washers (62), a 42mm Spacer (93), and an M12
Nylon Locknut (84).
Do not overtighten the
Locknut; the Wheel must be able to turn easily.
Attach the other Wheel (31) in the same
manner.
Before beginning assembly, make sure you
have read and understood the information in
the box above. This brief introduction will
save you more time than it takes to read it!
1
1
42
31
31
93
62
84
42
62
81
56
56
92
92
56
53
53
53
53
92
92