User's Manual
10
16. Insert the rod on the Backrest Frame (15) into the
slot in the Seat Carriage (12). Hold the Backrest
vertically over the Seat Carriage and slide the
rod into the slot, as shown in the inset drawing.
17. Locate the Long Cable (80). Slide one end of
the Cable through the Swivel Arm (22) as shown
in the inset drawing. Make sure the Cable is the
indicated side of the rod in the Swivel Arm.
Wrap the Long Cable (80) around a Large Pulley
(28). Attach the Pulley and a Arm Pulley Cover
(87) to the Swivel Arm (22) with an M10 x 45mm
Bolt (2) and an M10 Nylon Locknut (76).
18. Wrap the Long Cable (80) under a Large Pulley
(28). Attach the Pulley and a pair of Pulley
Covers (29) to the Upright (3) with an M10 x
140mm Bolt (72), an M10 Washer (75), and an
M10 Nylon Locknut (76).
Make sure that the
small tabs on the Pulley Covers are in the
indicated position.
16
17
18
15
15
12
12
Rod
Slot
Rod
2
22
22
28
80
76
Rod
80
87
76
28
Small
Tab
29
29
72
75
80
3