User's Manual

9
8. Insert the Backrest Support (7) into a set of
h
oles in the Uprights (1). Make sure that the
locking pin is on the side shown.
Rotate the Backrest Support (7) to the locked
position, with the locking pin wrapped around
the left Upright (1).
Apply grease to an M10 x 137mm Bolt (28).
Attach the Backrest Tubes (5) to the welded
tube on the Frame (2) with the M10 x 137mm
Bolt (28), two M10 Washers (26), and an M10
Locknut (25). Do not overtighten the Locknut;
the Backrest Tubes must pivot easily.
See steps 1–3. Tighten the M8 Locknuts (13)
used in these steps.
See step 7. Tighten the four M6 x 38mm
Screws (22).
9. Attach the Seat (11) to the brackets on the
Frame (2) with four M6 x 16mm Screws (21).
8
9
26
28
5
26
25
7
Welded
Tube
1
2
Locking
Pin
1
11
21
2
Grease