User's Manual

7
2. Orient the Base (31) so that the recessed holes
are facing the floor.
A
ttach the Base (31) to the Front Leg (8) with
two M8 x 38mm Carriage Bolts (29) and two M8
L
ocknuts (13). Do not tighten the Locknuts
yet.
2
13
13
29
Recessed
Holes
31
8
3. Attach the Front Leg (8) to the Frame (2) with
two M8 x 38mm Carriage Bolts (29), two M8
Washers (12), and two M8 Locknuts (13). Do
not tighten the Locknuts yet.
3
13
2
29
8
12
4. Apply some of the included grease to an M10 x
55mm Bolt (30).
Attach the Frame (2) to the upper set of holes
in the bracket on the Crossbar (3) with the M10
x 55mm Bolt (30) and an M10 Locknut (25). Do
not overtighten the Locknut; the Frame must
pivot easily.
Tighten the Lock Knob (23) into the bracket on
the Crossbar (3) and into the Frame (2).
See the inset drawing. Insert the Lock Pin (40)
into the lower set of holes in the bracket on the
Crossbar (3).
4
2
25
30
23
Grease
40
3