User's Manual

6
1.
Attach the Crossbar (3) to the two Uprights (1)
with four M8 x 53mm Bolts (14), four M8
Washers (12), and four M8 Locknuts (13). Do
not tighten the Locknuts yet.
1
3
1
14
12
14
12
13
13
1
13
13
ASSEMBLY
To make assembly easier, carefully read the fol-
lowing information and instructions:
•
Assembly requires two persons.
• Because of its weight and size, the weight bench
should be assembled in the location where it will
be used. Make sure that there is enough clear-
ance to walk around the weight bench as you
assemble it.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• For help identifying small parts, use the PART
IDENTIFICATION CHART on page 5.
• The following tools (not included) may be required
for assembly:
two adjustable wrenches
one rubber mallet
one standard screwdriver
one Phillips screwdriver
Assembly may be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
Before before beginning assembly, make
sure that you understand the information
in the box above.