User's Manual

8
14.
Attach the Curl Pad (37) to the Curl Post (38) with
two M6 x 16mm Screws (29).
11
28
24
22
Weight
Tube
22
25
13
14
25
14
15
19
1
12
13
14
27
37
38
29
9
9
12
25
11. Orient the Left Fly Arm (25) so that the short side
of the pivot tube is on the side shown.
Tap a 30mm Square Inner Cap (22) into each end
of the Left Fly
Arm (25). Press a 25mm Round
Inner Cap (24) into the end of the weight tube.
Slide a Weight Stop (28) onto the weight tube.
Assemble the Right Fly Arm (not shown) in
the same manner.
Short
Side of
Pivot
Tube
12. Tap a Fly Arm Stop (15) onto the welded tube on
each Upright (1).
Press two Plastic Bushings (14) into the indicated
holes in the left Upright (1). Attach the Left Fly
Arm (25) to the Upright using an M10 x 130mm
Bolt (19) and a Butterfly Knob (13). Make sure
the Fly Arm is on the outside of the Fly Arm Stop
(15). Do not overtighten the Butterfly Knob;
the Fly Arm must be able to pivot easily.
Assemble the Right Fly Arm (not shown) to
the right Upright (1) in the same manner.
13. Press two 19mm Round Inner Caps (9) into the
ends of a Short Pad Tube (12). Slide the Short
Pad Tube into the indicated hole in the Left Fly
Arm (25) as shown.
Push a Short Foam Pad (27) onto the Short Pad
Tube (12) as far as it will go; the Foam Pad will
hold the Pad Tube in place.
Repeat this step for the Right Fly Arm (not
shown).