User's Manual

7. Tap two 19mm Round Inner Caps (9) into each
Long Pad Tube (10). Insert the Long Pad Tubes
into the holes in the Leg Lever (4). Slide two Long
Foam Pads (23) onto each Long Pad Tube.
8. Tap two 25mm Square Inner Caps (35) into each
of the two Backrest Tubes (5).
Attach each Backrest Tube (5) to the Backrest (6)
with two M6 x 38mm Screws (30) and two M6
Washers (26).
Do not tighten the Screws yet.
9. Tap a 19mm Round Inner Cap (9) into each end
of the Support Rod (7). Insert the Support Rod
through a set of holes in the Uprights (1). Make
sure that the locking pin is on the side shown.
Rotate the Support Rod to the locked position,
with the locking pin wrapped around the Upright.
Lubricate the M10 x 137mm Bolt (36) with
grease. Attach the Backrest Tubes (5) to the
welded tube on the Frame (2) with the Bolt, two
M10 W
ashers (34), and an M10 Nylon Locknut
(33). Do not overtighten the Locknut; the
Backrest T
ubes must be able to pivot easily
.
Tighten the M6 x 38mm Screws (30) used in
step 8 and the M8 Nylon Locknuts (17) used in
steps 1–3.
10. Attach the Seat (11) to the brackets on the Frame
(2) with four M6 x 16mm Screws (29).
9
10
10
9
4
23
23
7
7
8
5
30
26
26
30
6
35
35
9
9
9
34
5
36
7
1
2
Welded Tube
Lubricate
1
Locking
Pin
33
34
10
1
1
29
2