User's Manual

9
10
11
9. Orient the Seat (11) with the wide end on the side
shown. Attach the Seat to the Bench Frame (2)
with four M6 x 16mm Bolts (15).
10. Insert 19mm Round Inner Caps (9) into both ends
of the three Pad Tubes (10). Slide the Pad Tubes
into the holes in the Leg Lever (4) and the Front
Leg (8). Slide two Foam Pads (22) onto each Pad
Tube.
11. Slide a Bushing (28) onto the bottom of each
Upright (1). Be sure the tab is on the indicated
side of the Bushing.
Press a 60mm x 50mm
Bushing (31) into the bottom of each Upright and
secure it with two M4 x 8mm Screws (34).
Attach the Right Barbell Hook (50) to an Upright
(1) with a Bright M8 Washer (47) and a Bright M8
Nylon Locknut (48). Attach the Left Barbell Hook
(49) to the other side of the other Upright in the
same manner. Orient the two Uprights as shown.
12. Hold the tabs on the Bushing (28) in the slots in
the left Upright (1). Slide the Upright and Bushing
into the left Upright Base (7), so that the tabs
snap into the slots in the Upright Base.
Note: Be
careful not to pinch your fingers
Align one of the adjustment holes in the Upright
(1) with the hole in the Upright Base (7). Tighten
an M10 x 62mm Adjustment Knob (30) into the
holes.
Attach the right Upright (1) to the right Upright
Base (7) in the same manner.
Note: Always set
both Uprights at the same height.
2
15
15
22
22
4
8
22
9
9
9
9
10
10
28
50
1
1
47
48
49
Tab
31
34
34
11
Wide
End
9
7
7
Adjustment
Hole
Slot
Tab
1
1
30
12
28
28
WARNING: Do not insert the
M10 x 62mm Adjustment Knob (30) through
the slot in the Upright (1).