User's Manual

6
2. Attach the Upright (3) to the Base (1) with the two
M8 x 63mm Carriage Bolts (58) and two M8
N
ylon Locknuts (69). D
o not tighten the
Locknuts yet.
Press a 25mm x 50mm Inner Cap (25) into the
tube on the Upright (3). Attach the Press Frame
Lock (39) to the Upright with an M8 x 63mm Bolt
(66), two M8 Washers (71), and an M8 Nylon
Locknut (69). Do not overtighten the Nylon
Locknut; the Press Frame Lock must be able
to pivot easily.
2
3
1
17
37
70
57
2
68
68
10
7
1
69
66
71
3
25
58
39
69
3. Set two Weight Bumpers (17) over the indicated
holes in the Stabiliser (2). Insert two Weight
Guides (10) into the same holes. Secure the
Weight Guides in place with two M10 x 70mm
Bolts (57), two M10 Washers (70), two M10 x
12.5mm Spacers (37), and two M10 Nylon
Locknuts (68).
T
ighten the Nylon Locknuts (68, 69) used in
steps 1 and 3.