User's Manual

ADJUSTING THE BACKREST

The Bench Backrest (69) can be used in a decline

position, a level position, or either of two incline posi-

tions. To adjust the Backrest to the decline position,

remove the Bench Pin (74) and insert it through the

top set of holes in the Backrest Frames (67, 68) and

the Bench Frame (63).

To adjust the Bench Backrest (69) to the level posi-

tion, insert the Bench Pin (74) through the second set

of holes from the top of the Backrest Frames (67, 68)

and the Bench Frame (63).

To adjust the Bench Backrest (69) to an incline posi-

tion, insert the Bench Pin (74) through one of the

lower two sets of holes in the Backrest Frames (67,

68) and the Bench Frame (63).

USING THE CURL PAD

Remove the 50mm Square Inner Cap (43) from the

Front Leg (64).

Align a hole in the Curl Post (83) with the hole in the

Front Leg (64). Secure the Curl Post with the Curl

Knob (4). Be sure the Knob is fully tightened.

Note: When not using the Curl Pad (84), store it

away from the weight bench.

WARNING: When adjusting the

position of the Bench Backrest (69), make sure

that the Bench Pin (74) is fully inserted through

both Backrest Frames (67, 68) and the hole in

the Bench Frame (63).