User's Manual

26. Wrap the Low Cable (33) around a 90mm Pulley

(24). Attach the Pulley and a Cable Trap (26) to

the second hole from the bottom of the two Pulley

Plates (28) with an M10 x 45mm Bolt (57) and an

M10 Nylon Locknut (49).

28. Attach the Backrest (13) to the Centre Upright (5)

with two M6 x 63mm Bolts (56) and two M6

Washers (59).

Before using the weight rack, pull each cable a

few times to be sure that the cables move

smoothly over the pulleys. If one of the cables

does not move smoothly, find and correct the

problem. IMPORTANT: If the cables are not

properly installed, they may be damaged

when heavy weight is used. See the CABLE

DIAGRAMS on page 20 for proper cable rout-

ing. If there is any slack in the cables, they

will need to be tightened; see TROU-

BLESHOOTING AND MAINTENANCE on page

21.

27. Attach the end of the Low Cable (33) inside the

hole in the Rear Upright (6) with an M10 x 65mm

Bolt (54), two M10 Washers (52) and an M10

Nylon Locknut (49).