User's Manual

9
9. Insert two M8 x 65mm Carriage Bolts (40) up
through a Rack Stabilizer (1). Attach the Left
Post (6) and the Left Base (2) to the Rack
Stabilizer with the Carriage Bolts, two M8 x
90mm Bolts (38), and four M8 Nylon
Locknuts (43).
Repeat this step with the other Rack
Stabilizer (not shown), the Right Base (not
shown), and the Right Post (not shown).
9
6
43
43
2
1
40
38
43
43
10. Insert the Right Base (51) into the Left Base
(2). Insert an M10 x 65mm Carriage Bolt (42)
up through the Left and Right Bases. Next,
tighten the Base Knob (31) onto the Carriage
Bolt.
10
51
31
42
2
1
1. Attach a Tray (18) to a Tray Support (10) with
two M8 x 45mm Bolts (39) and two M8 Nylon
Locknuts (43). Next, insert the Tray Support
(10) into the Left Upright (8).
Repeat this step for the other side of the
weight rack.
11
39
18
10
43
43
8
12. Make sure that all parts are properly tight-
ened before you use the weight bench
and the weight rack. The use of all remain-
ing parts will be explained in
ADJUST
-
MENT on page 10.
8. Insert the Seat Pin (29) into the Seat Frame
(5) and through the Bench Frame (4).
8
4
29
5