Instructions / Assembly

8
8. Orient the Backrest (7) as shown. Attach the
Backrest to the Backrest Frame (5) with four M6
x 16mm Screws (24).
See the inset drawing. Attach the tether on the
Locking Pin (21) to the underside of the Frame
(1) with an M4 x 16mm Screw (28). Next, insert
the Locking Pin into the Frame and into an
adjustment hole in the Pivot Bracket (6).
7
7. Apply some of the included grease to an M10 x
85mm Bolt (23).
Insert the Pivot Bracket (6) into the slot in the
Frame (1). Attach the Backrest Frame (5) to the
Frame with the M10 x 85mm Bolt (23) and an
M10 Locknut (19). Do not overtighten the
Locknut; the Backrest Frame must pivot
easily.
Then, attach an M10 x 20mm Bolt (25) and an
M10 Locknut (19) to the hole in the end of the
Pivot Bracket (6).
See step 6. Tighten the M10 Locknuts (19).
23
19
19
5
6
Grease
7
5
24
24
6. Attach the Pivot Bracket (6) to the Backrest
Frame (5) with two M10 x 70mm Bolts (26) and
two M10 Locknuts (19). Do not tighten the
L
ocknuts yet.
6
19
26
6
5
1
8
25
21
1
6
28