User's Manual

13
15. Press two Plastic Butterfly Bushings (79) and two
Metal Butterfly Bushings (93) into the Right
B
utterfly Arm (56). Wet the bottom of the Right
Butterfly Arm with soapy water and slide a
B
utterfly Foam Pad (66) onto the Right Butterfly
Arm.
Apply some of the included grease to a 1/2" x
78mm Bolt (97) and to the Plastic Butterfly
Bushings (79). Attach the Right Butterfly Arm (56)
to the Butterfly Bracket (55) with the Bolt and a
1/2" Nylon Locknut (94). Cover the Bolt and the
Nylon Locknut with two Butterfly Caps (80).
Do
not overtighten the Nylon Locknut; the Right
Butterfly Arm must pivot easily.
Repeat this step with the Left Butterfly Arm
(57).
16. Attach the Butterfly Backrest (101) to the Center
Upright (45) with two M6 x 75mm Screws (96)
and two M6 Washers (78).
15
79
Grease
Grease
80
9
7
94
80
55
56
9
3
93
57
79
66
16
101
78
96
78
96
45
17. IMPORTANT: See the CABLE DIAGRAM on
page 25 to identify the cables as you assem
-
ble them.
Identify the Medium Cable (69).
Route the
Cable up through the Weight Guide Top Frame
(49) and over a Pulley (87). Attach the Pulley
inside the Top Frame with an M10 x 75mm Bolt
(92), two M10 Washers (35), two 17mm Spacers
(89), and an M10 Nylon Locknut (34).
17
49
69
89
35
35
34
92
89
87