Manual

5. Attach the Bench Frame (1) to the center holes in
the Crossbar (4) withtwo M10 x 82mm Bolts (43)
and two M10 Nylon Locknuts (48).
Tighten the M10 Nylon Locknuts (48) used in
steps 1-5.
6. Press three 45mm Square Inner Caps (26) into
the Leg Lever (3). Press a 25mm Round Inner
Cap (33) into the Weight Tube (16).
Attach the Weight Tube (16) to the Leg Lever (3)
with an M8 x 58mm Bolt (42), two M8 Washers
(47), a 10mm Spacer (30), and an M8 Nylon
Locknut (51). Press a 25mm Round Angled Cap
(34) onto the end of the Weight Tube.
7,
Lubricate an M10 x 65ram Bolt (35) with grease.
Attach the Leg Lever (3) to the Front Leg (2) with
the Bolt and an M10 NylonLocknut(48). Do not
overtighten the Locknut; the Leg Lever must
be able to phtot easily.
Press four 25mm Square Inner Cap (28) intotwo
BackrestTubes (12).
Attach the BackrestTubes (12) tothe Backrest
Bracket (10) with four M6 x 38mm Bolts (40), four
M6 Washers (60), and four M6 Nylon Locknuts
(52).
8.
Insert the Backrest Bracket (10) into the slot in
the Bench Frame (1).
Lubricatean M10 x 168mm Bolt (41) with grease.
Attach the BackrestTubes (12) to the Bench
Frame (1) with the Bolt and an M10 Nylon
Locknut(48). Do not overtighten the Locknut;
the Backrest Tubes must be able to pivot easi-
ly.
7
4 Center
Holes
48
43
3
Lubricate
28
12
40 50 52 "'-"_
lo
8