User`s manual

30. Attach a 90mm Pulley (48) to the Front Leg (10)

with an MIO x 65mm Bolt (85), two MIO Washers

(80), two 13mm Steel Spacers (109), and an MIO

Nylon Locknut (77). Make sure the Leg Lever

CabJe (51) is under the Pulley.

31. Route the Leg Lever Cable (51) under the

89.5mm Spacer (59), through the Upright (2), and

under the indicated rod in the Base (1). Wrap the

Leg Lever Cable around a 90mm Pulley (48).

Attach the Pulley to the Base with an MIO x

45mm Bolt (86), two Half Guards (55), and an

MIO Nylon Locknut (77).

32. Wrap the Leg Lever Cable (51) over a 90mm

Pulley (48). Attach the Pulley, a Cable Trap (56),

and two Half Guards (55) to the second hole from

the bottom of the Pulley Plates (60) with an MIO

x 50mm Bolt (97) and an MIO Nylon Locknut

(77). Make sure the Cable Trap and the Half

Guards are oriented as shown.

1 55 77

/ Rod