User`s manual

24. Route the Lat Cable (49) over a Thin Pulley (24)

and down through the Top Frame (4). Hold the

Thin Pulley inside the Top Frame. Insert an MIO x

80mm Bolt (84) through an MIO Washer (80), a

19mm Spacer (67), the Top Frame, and the Thin

Pulley.

25. Wrap the Lat Cable (49) under a 90mm Pulley

(48). Attach the Pulley, a Cable Trap (56), and

two Half Guards (55) at the second hole from the

top of the two Pulley Plates (60) with an MIO x

50mm Bolt (97) and an MIO Nylon Locknut (77).

Make sure the Cable Trap and Half Guards are

oriented as shown.

26. Route the Lat Cable (49) up through the Top

Frame (4) and wrap the Cable over a Thin Pulley

(24). Pull the MIO x 80mm Bolt (84) out of the

Top Frame until it is flush with the first Thin Pulley

from step 24. Do not remove the Bolt com-

pletely from the Top Frame.

Hold the second Thin Pulley (24) inside the Top

Frame (4) and attach it with the MIO x 80mm Bolt

(84), a 19mm Spacer (67), an MIO Washer (80),

and an MIO Nylon Locknut (77).