User`s manual

21. Wrap the Butterfly Cable (50) over a "V'-pulley
(47). Attach the "V'-pulley, a Long Cable Trap
(57), an MIO Washer (80), and two Guards (54)
to the Upright (2) with an MIO x 60mm Bolt (79)
and an MIO Nylon Locknut (77).
22. Grease an M8 x 22mm Shoulder Bolt (90). Attach
the Butterfly Cable (50) to the Right Butterfly Arm
(29) with the Shoulder Bolt and an M8 Nylon
Locknut (78). Make sure the flat edge of the
Cable is against the Butterfly Arm.
23. Identify the Lat Cable (49). Route the Cable up
through the Top Frame (4) and over a 90mm
Pulley (48). Attach the Pulley inside the Top
Frame with an MIO x 80mm Bolt (84), two MIO
Washers (80), two 19mm Spacers (67), and an
MIO Nylon Locknut (77).
21
22
23
54
.57
50
47
5O
90
29
Flat Edge
48
84 4
16