User`s manual

Cable Assembly 18

18. See the CABLE DIAGRAMS on page 28 to identi-

fy the cables as you assemble them.

identify the Butterfly Cable (50). Grease an

M8 x 22ram Shoulder Bolt (90). Attach the Cable to

the Left Butterfly Bracket (28) with the Shoulder Bolt

and an M8 Nylon Locknut (78). Make sure the fiat

edge of the Cable is against the Butterfly Arm.

Do not overtighten the Shoulder Bolt; the Cable

must be able to pivot freely.

19. Wrap the Butterfly Cable (50) over a "V'-pulley

(47). Attach the "V'-pulley, a Long Cable Trap

(57), an MIO Washer (80), and two Guards (54)

to the Upright (2) with an MIO x 60mm Bolt (79)

and an MIO Nylon Locknut (77).

20. Wrap the Butterfly Cable (50) under a 90mm

Pulley (48). Attach the Pulley and two Half

Guards (55) to the Double "U'-bracket (61) with

an MIO x 45mm Bolt (86) and an MIO Nylon

Locknut (77). Make sure the Half Guards are

oriented as shown.

Flat Edge

55 _61