User`s manual

15
26. Route the High Cable (55) over a 90mm Pulley
(48) and down through the Top Frame (4). Attach
the Pulley inside the Top Frame with an M10 x
67mm Bolt (71), two M10 Washers (57), two
12mm Spacers (52), and an M10 Nylon Locknut
(56).
25. Route the High Cable (55) up through the Top
Frame (4) and over a 90mm Thin Pulley (47).
Attach the Pulley inside the Top Frame with the
M
10 x 67mm Bolt (71) used in step 23, an 11mm
Spacer (49), an M10 Washer (57), and an M10
N
ylon Locknut (56).
71
55
52
52
48
57
4
57
56
26
5
5
47
71
4
49
5
7
56
25
55
82
78
24
27
27. Completely thread an M12 Nut (82) onto the High
Cable (55). Place a Large Washer (78) on top of
the Weight Selector (24).
Tighten the High Cable (55) into the Weight
Selector (24) until all the slack is removed from
the cables. Tighten the M12 Nut (82) against the
Large Washer (78).