User`s manual

14
22. Identify the High Cable (55). Route the Cable up
through the Top Frame (4) and over a 90mm
Pulley (48). Attach the Pulley inside the Top
Frame with an M10 x 67mm Bolt (71), two M10
Washers (57), two 12mm Spacers (52), and an
M10 Nylon Locknut (56).
23. Route the High Cable (55) over a 90mm Thin
Pulley (47) and down through the Top Frame (4).
Attach the Thin Pulley inside the Top Frame with
an M10 x 67mm Bolt (71), an M10 Washer (57),
and an 11mm Spacer (49). Make sure that the
Thin Pulley does not fall out of the Top Frame
while you complete steps 24 and 26.
21. Attach the Low Cable (53) to the U-bracket (45)
with an M8 Washer (59) and an M8 Nylon
Locknut (58). See the inset drawing. Do not
o
vertighten the Nylon Locknut; it should be
threaded onto the end of the Cable so that
o
nly two threads are showing above the Nylon
Locknut.
4
55
49
57
47
71
23
56
4
55
52
52
57
57
48
22
53
45
58
58
45
59
53
21
24. Wrap the High Cable (55) under a 90mm Pulley
(48). Attach the Pulley, a Cable Trap (51), and
two Half Guards (43) at the upper hole in the U-
bracket (45) with an M10 x 51mm Bolt (66) and
an M10 Nylon Locknut (56). Make sure that the
Cable Trap is oriented to hold the Cable in the
groove of the Pulley and that the Half Guards
are on the outside of the U-bracket.
66
51
56
48
55
43
43
45
24
71