User's Manual

9
The weight bench is designed to be used with your own weight set (not included). The steps below explain how
the weight bench can be adjusted. See Exercise Guidelines on page 10 for important exercise information and
refer to the accompanying exercise poster to see the correct form for each exercise. Refer also to the
exercise information accompanying your weight set (not included) for additional exercises.
Inspect and tighten all parts each time you use the weight bench. Replace any worn parts immediately. The
weight bench can be cleaned with a damp cloth and a mild, non-abrasive detergent. Do not use solvents.
ADJUSTING THE BACKREST
The Backrest (6) can be used in either a declined
position or any of three inclined positions. To use the
Backrest in a declined position, remove the Support
Rod (7) and lay the Backrest on the Frame (2).
To use the Backrest (6) in an inclined position, first lift
the Backrest. Insert the Support Rod (7) through one
of the three sets of holes in the Uprights (1). Rotate
the Support Rod to the locked position, with the end
of the Support Rod clipped onto the Upright. Lay the
Backrest on the Support Rod.
ATTACHING WEIGHTS
To use the Leg Lever (4), slide the desired weights
(not included) onto the weight tube.
WARNING: Do
not place more than 50 pounds (23 kg) on the Leg
Lever.
1
7
4
2
W
eight T
ube
W
eight
6
Adjusting the Weight Bench