User's Manual

8
7. Attach one Backrest Tube (5) to the Backrest (6)
with two M6 x 38mm Screws (16) and two M6
W
ashers (26). Attach the other Backrest Tube to
the Backrest with one M6 x 38mm Screw and one
M
6 Washer. N
ote: Do not tighten the three
Screws yet. A fourth M6 x 38mm Screw will be
attached later.
8. Tap a 3/4” Round Inner Cap (9) into each end of
the Support Rod (7). Insert the Support Rod
through one of the three sets of holes in the
Uprights (1). Rotate the Support Rod to the
locked position, with the end of the Support Rod
clipped onto the Upright.
See the inset drawing. Slide the ends of both
Backrest Tubes (5) onto the pin on the Frame (2).
Attach the free end of the Backrest Tube (5) to
the Backrest (6) with an M6 x 38mm Screw (16)
and an M6 Washer (26).
Fully tighten all four
M6 x 38mm Screws.
9. Attach the Seat (11) to the brackets on the Frame
(2) with four M6 x 16mm Screws (15) and four M6
Washers (26).
7
5
16
16
26
26
26
16
6
8
9
6
6
5
2
5
11
15
26
2
16
5
7
1
2
9
9
Pin
1
26
26
10. Make sure that all parts are tight before you use the weight bench. After the weight bench is assembled,
some extra hardware may be left. Cover the floor beneath the weight bench for protection.