User's Manual

3. Make sure that the Uprights (1) are turned as
shown. The high sides of the weight rests must
be on the indicated side.
Attach the Frame (2) to
t
he Crossbar (3) with two M8 x 57mm Bolts (14), two
M
8 Washers (12), and two M8 Nylon Locknuts (13).
4. Tap a 30mm Square Inner Cap (22) into each end
of the Leg Lever (4).
Tap a 1” Round Inner Cap (24) into the indicated
end of the weight tube. Tap the 1” Angled Round
Cap (20) onto the other end of the weight tube.
5. Lubricate the M10 x 63.5mm Bolt (18). Attach the
Leg Lever (4) to the Frame (2) with the Bolt, the
M10 Washer (25), and the M10 Nylon Locknut (19).
6. Tap two 3/4” Round Inner Caps (9) into each Pad
Tube (10). Insert the Pad Tubes into the holes in
the Leg Lever (4). Slide two Foam Pads (23) onto
each Pad Tube.
3
1
2
22
24
25
9
10
9
4
23
23
19
2
4
4
20
22
3
1
4
12
12
13
14
6
5
18—Lubricate
4
7
High Sides of
Weight Rests
1