User's Manual

12
120. Route the Low Cable (53) under a 90mm
Pulley (48). Attach the Pulley and two Half
Finger Guards (43) to the Base (1) with an
M
10 x 46mm Bolt (81) and an M10 Nylon
Locknut (56). Make sure the Finger Guards
a
re on the outside of the bracket as
shown.
22. Locate the High Cable (55). Route the Cable up
through the Top Frame (4) and over a 90mm
Pulley (48). Attach the Pulley inside of the Top
Frame with an M10 x 67mm Bolt (71), two M10
Washers (57), two 12mm Spacers (52), and an
M10 Nylon Locknut (56).
23. Route the High Cable (55) over a 90mm Thin
Pulley (47) and down through the Top Frame (4).
Attach the Pulley inside of the Top Frame with an
M10 x 67mm Bolt (71), an M10 Washer (57), and
an 11mm Spacer (49). Make sure that the
Pulley does not fall out of the Top Frame while
completing steps 24 and 26.
21. Attach the Low Cable (53) to the “U”-bracket (45)
with an M8 Washer (59) and an M8 Nylon
Locknut (58). See the inset drawing. Do not
overtighten the Nylon Locknut; it should be
threaded onto the end of the Cable so that
only two threads are showing above the Nylon
Locknut.
20
21
22
23
53
43
1
43
81
56
53
45
58
58
45
59
53
56
4
55
52
52
57
57
48
71
4
55
49
57
47
71
48