User's Manual

11
16. Locate the Low Cable (53). Route the Cable
through the Leg Lever (8) and the Front Leg (7).
A
ttach a 90mm Pulley (48) inside of the Leg
Lever (8), over the Low Cable (53), with an M10 x
6
7mm Bolt (71), two M10 Washers (57), two
12mm Spacers (52), and an M10 Nylon Locknut
(56).
18. Route the Low Cable (53) under a 90mm Pulley
(48) and through the Upright (3). Attach the Pulley
inside of the upright with an M10 x 67mm Bolt
(71), two M10 Washers (57), two 12mm Spacers
(52), and an M10 Nylon Locknut (56).
19. Route the Low Cable (53) over a 90mm Pulley
(48). Attach the Pulley and two Half Finger
Guards (43) to the Double “U”-bracket (63) with
an M10 x 46mm Bolt (81) and an M10 Nylon
Locknut (56). Make sure the Finger Guards are
on the outside of the “U”-bracket as shown.
17. Attach a 90mm Pulley (48) inside of the Front Leg
(7), over the Low Cable (53), with an M10 x
67mm Bolt (71), two M10 Washers (57), two
12mm Spacers (52), and an M10 Nylon Locknut
(56).
16
8
7
5
3
52
52
57
57
48
71
56
17
56
7
53
52
52
57
57
48
71
18
56
3
53
52
52
57
57
48
71
19
56
53
48
43
43
63
81