User's Manual

1.
Press three 50mm Square Inner Caps (30) into
the Base (1) and the Stabilizer (2).
Insert two M10 x 68mm Carriage Bolts (60) up
into the Stabilizer (2). Insert four M10 x 65mm
Carriage Bolts (64) up into the Base (1) (see the
inset drawing). Note: It may be helpful to place
a piece of tape over the bolt heads to hold
them in place.
Slide the Base (1) onto the two M10 x 68mm
Carriage Bolts (60) in the Stabilizer (2).
2. Lubricate an M10 x 77mm Bolt (75) with grease.
Attach the Squat Base Plate (3) to the Stabilizer
(2) with the Bolt and an M10 Nylon Locknut (80).
Do not overtighten the Locknut; the Squat
Base Plate must be able to pivot easily.
Attach the tether on the Short Pin (56) to the
Stabilizer (2) with an M4 x 16mm Self-tapping
Screw (82). Insert the Pin through the Stabilizer
and the Squat Base Plate (3).
Press two 25mm Round Outer Caps (36) onto the
Rear Upright (6).
Orient the Rear Upright (6) as shown. Slide the
Rear Upright onto the indicated M10 x 68mm
Carriage Bolts (60) and thread two M10 Nylon
Locknuts (80) onto the Bolts. Do not tighten the
Locknuts yet.
1
6
36
Insert Bolt
through
this hole
This angle
is less
than 90
degrees
36
82
56
75
80
60
80
80
2
3
30
30
30
2
64
1
1
2
Before beginning assembly, make sure you
understand the information in the box on
page 6. Refer to the PART IDENTIFICATION
CHART in the center of this manual for help
identifying small parts.
7
Frame Assembly
60
64