Security Datasheet

Safety Data Sheet according to Regulation (EC)
No. 1907/2006 (REACH)
Printed 08.01.2016
revision 05.01.2016 (GB) Version 1.2
Repair Stick Titanium
WEICON GmbH & Co. KG Königsberger Straße 255 D-48157 Münster / Federal Republic of Germany Page 5/9
Hand protection
In the cases of special applications, it is recommended to check the chemical resistance with the manufacturer of the
gloves.
Glove material specification [make/type, thickness, permeation time/life, wetting resistance]:: Nitrile rubber; 0,4mm;
480min;60min.
Chemical protective gloves must be chosen carefully in view of their design and depending on the dependence on the
concentration and amounts of dangerous goods used in the specific working tasks.
Eye protection
tightly fitting goggles
Other protection measures
protective clothing
Appropriate engineering controls
Sufficient ventilation and exhaustion.
SECTION 9: Physical and chemical properties
9.1. Information on basic physical and chemical properties
Appearance
pasty
Colour
brown
Odour
hardly noticeable
Odour threshold
not determined
Important health, safety and environmental information
Value Temperature at Method Remark
pH value
not applicable
boiling point
> 35 °C ca. 101 kPa
melting point
not applicable
Flash point
> 100 °C
Vapourisation rate
not applicable
Flammable (solid)
not determined
Flammability (gas)
not determined
Ignition temperature
not determined
Self ignition temperature
not determined
Lower explosion limit
not determined
Upper explosion limit
not determined
Vapour pressure
< 500 Pa 20 °C
Relative density
1,9 g/cm3
Vapour density
not applicable
Solubility in water
insoluble