User`s manual

Network Camera User’s Manual
5/53
Connections
Hardware description
1. DC Power Jack
The DC power input jack is located on the rear of Network Camera’s. The input power is
12VDC. Note that supply the power to the Network Camera with standard power adapter
included in package. Otherwise, the improper power adapter may damage the unit and
result in danger.
2. LAN Socket
Beside the DC power Jack, the LAN socket is an RJ-45 connector for connections to
10Base-T or 100Base-TX Fast Ethernet cabling. Please use Category 5 “straight
through” cable to connect the Network Camera to an Ethernet network switch or hub.
3. Antenna (Wireless model only)
4. Microphone
The Network Camera’s has built-in an internal microphone. This microphone is also
hidden in the pinhole located on the head of camera.
5. Front LEDs
Red LED indicate power, red LED will turn on always after plug-in power.
Orange LED indicate audio, orange LED will turn off if audio is set as mute.
Green LED indicate networking, green LED will blink every second after getting ip
address.
Upon powering up, three of front LEDs will become lighted then the camera will do
self-rotation. During the self-rotation, red LED will be on and the network camera is
standby for getting ip address.
6. Infrared LEDs and Light sensor
There are six Infrared (IR) LEDs and a light sensor in front of the head of camera for
night vision purpose. The IR LEDs will auto or manual turn on when the camera is in the
dark environment.
7. Factory Default Reset
This button is hidden in the pinhole under then Network Camera’s bottom. Please refer
to the Appendix A in this manual for more information.