User`s manual

Network Camera User’s Manual
49/53
Maintenance
“Reboot system” The “Reboot” button will reboot the Network Camera. It’s useful
while the Network Camera got problem.
“Factory default” Click on Factory default button on the configuration page to restore
the factory default settings. Any changes made so far will be lost and the system will be
reset to the initial factory settings. The system will restart and require the installer
program to set up the network again.
“Calibrate”
Recalibrate the home position to the default center to recover the tolerance
cased by some external forces. Please note that there is no confirming message box
after clicking on the “Calibrate” button, the Network Camera will calibrate immediately.
“Upgrade firmware” Select the firmware file and click upgrade button. Please be
aware that you should not turn off the power during updating the firmware and wait for
finish message.
Warning: The upgrade firmware procedure cannot be interrupted. If the power
and/or network connection are broken during the procedure, it might possibly
cause serious damage to the Network Camera.
Note: When upgrade firmware please wait for 90~180 seconds, and then you can
connect to Network Camera again. The system will restart and require the installer
program to set up the network again.