User`s manual

Network Camera User’s Manual

31/53

》 “WPA-PSK” – Use WPA pre-shared key.

》 “WPA2-PSK” – Use WPA2 pre-shared key.

》 “Auth Mode” Choosing one of the following modes, (Default original setting is

OPEN).

》 “Open” – communicates the key across the network.

》 “Shared” – allows communication only with other devices, which are with

identical WEP settings.

》 “Key length” The administrator can select the key length of 64 or 128 bits. 64bits is

the default setting.

》 “Key format” Hexadecimal or ASCII. “HEX” is the default setting.

》 “HEX” digits consist of the numbers 0~9 and the letters A-F.

》 “ASCII” is a code for representing English letters as numbers from 0-127 except

“, <, > and space characters that are reserved.

》 “Network Key” Entering a key in either hexadecimal or ASCII format. When

selecting different key length, acceptable input length is listed as following:

64 bits key length: 10 Hex digits or 5 characters.

128 bites key length: 26 Hex digits or 13 characters.

Note: When 22(“), 3C(<) or 3E(>) are input in network key, the key format can’t be

changed to ASCII format.

》 “Algorithm” Choosing one of the following algorithm for WPA-PSK modes

》 “TKIP”

》 “AES”

》 “Pre-shared Key” Entering a key in ASCII format. The length of the key is 8 ~ 63

“Ad-Hoc” Make the Network Camera connect directly to a host equipped with a

wireless adapter in a peer-to-peer environment.

》 “Channel” Under infrastructure mode, the channel will be selected automatically to

match the channel setting for the selected Access Point. Under Ad-Hoc mode, the

channel must be manually set to the same channel for each wireless adapter. The

default channel setting depends on the installed region.

》 “TX rate” This field is for selecting the maximum transmission rate on the network.

The default setting is “auto”. It means the Network Camera will try to connect to the other

wireless device with highest transmitting rate.

》 “Security” Select the data encrypt method

》 “None” – No data encryption.

》 “WEP” – allows communication only with other devices, which are with identical

WEP settings.