User`s manual

Network Camera User’s Manual
29/53
to check the IP address assigned to the Network Camera if the IP address is forgotten,
or user can use the UPnP function provided by the Network Camera (MS Windows XP
provides UPnP function at My Network Place).
》“IP address” This is necessary for network identification.
》“Subnet mask”
This is used to determine if the destination is in the same subnet.
The default value is “255.255.255.0”.
》“Default router”
This is a gateway used to forward frames to destinations in a
different subnet. Invalid router setting will fail the transmission to destinations in different
subnet.
》“Primary DNS” The primary domain name server that translates hostnames into IP
addresses.
》“Secondary DNS” Secondary domain name server backups the Primary DNS.
》“Enable UPnP” Enable UPnP ability.
“PPPoE”
If using the PPPoE interface, should fill the following settings from ISP
》“User name” The login name of PPPoE account
》“Password” The password of PPPoE account
》“Confirm password” Input password again for confirmation
HTTP
“Http port” This can be typed besides the default Port 80. Once the port is changed,
the users must make sure the change for the connection is successful. For instance,
when the Administrator changes the HTTP port of the Network Camera which IP address
is 192.168.0.20 from 80 or 1025 to 65535, the users must type in the web browser
“http://192.168.0.20:8080” instead of “http://192.168.0.20”.
Stream server
“Stream port”
Stream port can be typed besides the default Port 53
RTSP Streaming
The RTSP streaming currently supports video only, audio only, and audio/video. To use
the audio stream, type the url as “rtsp://61.30.125.43:554/audio”. To use the video
stream, type the url as “rtsp://61.30.125.43:554/videoN”. To use the audio/video stream,
type the url as “rtsp://61.30.125.43:554/avN”. The valid value for “N” is 2 and 3. When
the stream contains audio data, the audio codec at camera must select AMR.
“RTSP Port” RTSP port can be typed besides the default Port 554