User`s manual

Network Camera User’s Manual
28/53
Network
Any changes made on this page will restart the system in order to validate the changes.
Make sure every field is entered correctly before clicking on “Save”
Network type
“LAN” & “PPPoE”
The default type is LAN. Select PPPoE if using ADSL
"Get IP address automatically" & “Use fixed IP address”
The default status is “Get IP address automatically”. This could be tedious to perform
software installation whenever the Network Camera starts. Therefore, once the network
is set, especially for the IP address should be entered correctly. Select “Use fixed IP
address” then the Network Camera will skip installation. The Network Camera will
automatically restart and operate normally after a power outage. User can run IP installer