Service Manual

Weichai America Corp.

Revision: August 2019 32

2 Bolt 11 Bolt

3 Front Oil Seal 12 Bolt

4 Shaft 13 Bolt

Intermediate

Shaft

14 Oil Fill Plug

6 Intermediate Gear 15 Washer

7 Plate 16 Stud

8 Bolt 17 Nut

9 Bolt

8.2.2 Gear Housing Disassembly Procedure

1. Remove the intermediate gear.

2. Remove the front cover plate (See Key Point 1 under section 8.2.4).

3. Remove the front oil seal (See Key Point 2 under section 8.2.4).

8.2.3 Gear Housing Assembly Procedure

Reverse the Disassembly Procedure (8.2.2) to assemble the Gear Housing.

8.2.4 Gear Housing Inspection and Maintenance

Key Point 1:

Inspection:

Check the gear housing to ensure that it is clean and without any damage or burrs on the

fitting surface. Check the O-Rings to ensure that they are in good condition. Replace the O-

Rings if necessary.

Assembling:

(1) Knock the locating pins into place, as shown in the figure below;

WEICHAI & PSI SERVICE MANUALS AVAILABLE ONLINE AT FLYPARTSGUY.COM

GET YOUR WEICHAI & AFTERMARKET SERVICE PARTS AT FLYPARTSGUY.COM