Use and Care Manual

II HOW TO SET UP YOUR SOD CUTTER

CAUTION:

Wear protective gloves during operation of setting up your sod cutter.

1) Remove the temporary bracket, and then install the components of handle-bar & rod, and then

connect the screw end of clutch cable to the belt clutch handle according to installing drawing.

2) Make sure the handle bar have been connected to the machine correctly and all bolts have

been tightened securely.

3) Check the tensional spring to ensure the clutch

cable connected correctly. The cable travel should

be 1.9-2.54cm and the cable is easy to reset.

Check and make sure the engine has enough oil in

5) Refer to engine operator's manual for further details

Machine Overview

The following is a list of important control and operation mechanisms with which the operator

must be familiar PRIOR to using this machine . Failure to do so may result in severe injury

and/or fatality to the operator and others and may lead to reduced machine life or damage to this

machine.

Ｇｅａｒ　ｂｏｘ

Ｔｅｎｐｏｒａｒｙ　ｂｒａｃｋｅｔ

Ｈａｎｄｌｅ　ｂａｒ

ｓｐａｃｅｒ

Ｒｏｄ

Ｐａｒｔｓ　ｒｅｌａｔｉｏｎｓｈｉｐＡｓｓｅｍｂｌｅｄ

Ｎｙｌｏｎ

Ｂｅｌｔ　ｔｅｎｓｉｏｎｅｄ　ｐｏｓｉｔｉｏｎ

Ｂｅｌｔ　ｒｅｌｅａｓｅｄ　ｐｏｓｉｔｉｏｎ

Ｃａｂｌｅ　ｓｈｅａｔｈ

２－３ｃｍ

Ｃａｂｌｅ　ｂｒａｃｋｅｔ

Ｐｉｎ　

Ｎｙｌｏｎ　ｓｐａｃｅｒ

Ｃｏｔｔｅｒ　ｐｉｎ

Ｃｌｕｔｃｈ　ｃａｂｌｅ　ｈｅａｄ

Ｓｐｒｉｎｇ　ｏｐｅｎｅｄ

Ｔｅｎｓｉｏｎａｌ　ａｒｍ

crankcase.

of running an engine.

Ｎｕｔ

Ｕ　ａｄａｐｔｅｒ

Ｐｉｎ　ｋｉｔｓ

Ｃｏｎｎｅｃｔｉｎｇ　ｒｏｄ

Ｕ　ａｄａｐｔｅｒ

Ｐａｒｔｓ　ｒｅｌａｔｉｏｎｓｈｉｐ

Ｃｈｅｃｋ　ｔｅｎｓｉｏｎａｌ　ｓｐｒｉｎｇ