Use and Care Manual

Carefully read these instructions and this manual in its entirety, before you attempt to operate

your new shredders.

IMPORTANT: THIS SOD CUTTER IS DELIVERED WITHOUT OIL OR PETROL IN THE

ENGINE.

Your new sod cutter has been pre-assembled at the factory, with the exception of those parts left

unassembled for shipping purposes. All parts such as nuts, washers, bolts, etc. necessary to

complete the assembly have been attached on the machine. To assure safe and proper operation

of your sod cutter all parts and hardware you assemble must be tightened securely. Use the

correct tools needed to assure proper tightening.

I UNPACKING INSTRUCTIONS

WARNING

To prevent personal injury or property damage, do not attempt to start the engine until all

assembly steps are complete and you have read and understand the safety controls and

operating instructions in this manual.

INTRODUCTION

Please carefully follow these assembly steps to properly prepare your machine for use. We

recommend that you read this Section in it’s entirely before beginning assembly.

NOTE: All references to left, right, front and rear of the machine are determined by standing

behind the handlebars and facing the direction of forward travel.

INSPECTION AFTER DELIVERY

When unpacking the machine, inspect for shipping damage or missing parts, if you find any

damage, or if parts are missing, notify the WEIBANG Dealer who sold you the machine.

TOOLS/MATERIALS NEEDED:

Active Wrench / Motor Oil / Tire Gauge

1. UNPACKING STEPS

• Cut plastic banding. To open the box, remove top plywood panel firstly,

• Remove the handle bar with belt clutch handle.

• Remove all around wall panel.

• Remove the angle iron securing machine to wood pallet.

• Move the machine from the wood pallet.

• Check the box thoroughly and remove additional loose parts included with sod cutter.

• Remove all packing materials.

● The WBSC409H is a HEAVY machine. The net weight is 387 lbs/176kgs. DO NOT ATTEMPT

TO MANUALLY LIFT ALONE! It is recommended extremely using a crane to lift the unit.

If there is no crane for lifting, make sure that four people lifting the machine

are capable of lifting at least 100 lbs/45.36kgs individually!! NEVER ATTEMPT

TO LIFT THE MACHINE WITH ONLY ONE or TWO PERSON!!