Specifications

TMAP# Target
This commands allows you to change the TMAP to another target. The defaults are listed in
the TMAP section. A section under the system statistics shows the current mapping on the
AMR-100 receiver. The target can be any one of seven targets:
T1 = Port 1 stereo
T1L = Port 1 mono – left side only
T1R = Port 1 mono – right side only
T2 = Port 2 stereo
T2L = Port 2 mono – left side only
T2R = Port 2 mono – right side only
None = No target – a file will NOT play
Seven TMAPs exist: TMAP0, TMAP1, TMAP2, TMAP3, TMAP4, TMAP5 and TMAP6.
TMAP0 is for special or emergency broadcasts.
Syntax: TMAP1 T1
TMAP1 T2L
Rev. 36 – Firmware version 1.61 56
©
2008