Specifications

Trigger Event Lists
This link takes you to a page listing events that happen on
an input closure or on a command sent by satellite or serial
port. The system calls these trigger events. If an event
happens on a closure sent by a program producer, then it
will have a serial string that causes a program or spot to air.
This text is listed. If an input closure is used, they are
described as Input 1, Input 2, Input 3 or Input 4. There can
be a maximum of 100 triggers, but only those that are used
are listed. The example to the right shows six trigger
events.
Clicking on one of the events is shown in the following illustrations. The first one shows a
trigger based upon a text command sent to the receiver. Notice that it has the same
information as the Scheduled event. However, the chart does not populate until the text has
been sent and the trigger has caused a file to play.
The following illustration shows an input closure trigger.
Rev. 36 – Firmware version 1.61 50
©
2008