Specifications

Scheduled Event List
This page shows the scheduled timed events in the
playlist (see PLAYLIST section). When you first install
your receiver, this will have no entries as shown below.
Action is the type of event that will happen.
Time is time and/or date when the event will
happen.
Source is what file or program will be played.
Target is where the output has been addressed.
Level shows how much the signal has been attenuated by showing its relative volume. A
setting of 0dB means there is no attenuation and a reading of –inf means it is
completely off.
Ramp shows the fade listed in playlist file for that file or event. It shows how many
seconds of fade the program will have at the end of the file.
Output Target shows you which output Port is being used
State shows whether the output is active or not. When it is blank, the output is not being
used for that action and a “1” means the output is active.
The following shows two files. One will be played at 01:30:00 and the other one at
02:00:00.
The column labeled Action has the following entries:
OPEN/SEEK is when the AMR-100 “cues” the file. It does that one second before it
plays.
PLAY shows that it will play at 01:30:00.
STOP shows when the file will end at 01:52:00.
The Time column shows when each event will happen. The Source column shows the
exact name of the file that will play. Target shows the port that will be used to play
the file. Level shows the starting, playing and ending volume (-inf = off, 0dB = full
volume). The Ramp shows how the file will be faded.
Rev. 36 – Firmware version 1.61 49
©
2008