Specifications

DATE MENU
Only three options exist on the Date Menu:
Date and time
Zone
Daylight Saving Time
In a few minutes after connecting the RF to the
AMR-100, it will sync its time based on the
embedded time in the RF carrier. The carrier
sends GMT and the receiver changes the hours
to reflect the Zone and Daylight Saving Time setting.
After the time is synced from the RF carrier, you CANNOT change the date and time. When
you enter the edit mode in this menu, you will be taken to the Zone setting and NOT be able
to change the date or time. If the month is highlighted when you press [ENTER], then you
either have entered the menu before the time sync or the RF is not connected.
Date Time:
The receiver wakes up based on the time setting it had during testing at the factory.
You may change this only before the AMR-100 syncs its time with the RF carrier.
Time Zone:
Zone: Eastern (default)
The zone can be set to any time zone. When changing the Time Zone setting, the hour
display will change automatically to reflect the new time zone. Only seven zones are
named. The other zones are reflected in hours to or from GMT (GMT-1, GMT+12,
etc.) The names zones are:
• Atlantic
• Eastern
• Central
• Mountain
• Pacific
• Alaska
• Hawaii
After the clock has received its time sync from the RF carrier, the time
immediately changes to reflect a change in the zone. Thus, changing the zone
from Eastern to Central at 11:34:35 will cause the time to change to 10:34:35
immediately.
Rev. 36 – Firmware version 1.61 39
©
2008
Date Time
Zone
Daylight Saving
DATE