Specifications

*LCD Settings
This changes the contrast of the display. Be very
careful, because you can make the display
unreadable and you will have to reset the receiver to
its default settings (see RESETTING THE
RECEIVER TO DEFAULT SETTINGS section).
1. Press [ENTER] to edit the Resistance Ratio
2. Press [UP] or [DOWN] to change the settings – this makes “coarse” adjustments to
the contrast of the display
3. Press [ENTER] to move to Reference Voltage
4. Press [UP] or [DOWN] to change the settings – this makes “fine” adjustments to the
contrast of the display
5. Press [ENTER] to save your settings and return to the Settings submenu
HD Model: ST38021 5A (This is the model number of the internal hard drive)
HD Size: 76319meg (This is the size of the internal hard drive – approximately 80 GB)
*Audio Test
1. Press [ENTER] to start the test. It will generate two different tones (a lower tone on the
left channel and a higher tone on the right channel). The display will say:
2. Press any key to exit the test (as described on the display)
Rev. 36 – Firmware version 1.61 38
©
2008
WARNING
If you adjust the display to an unreadable condition, you can restore the display
by using a “Cold Boot.” This is done by unplugging the AMR-100 receiver and
press and hold the [ENTER] button as you plug in the AMR-100. This will
reset the display to its normal settings.
A Cold Boot will stop the audio playback and it must be rebooted to restore the
audio playback!
Resistance Ratio
Reference Voltage
LCD Settings
Now playing a low tone
on the left, and a high
tone on the right. Press
any key to exit this test.