Specifications

*Cmd Addr: 239.239.239.128 (This should never change unless instructed to do so by
support personnel. It is the port used to send commands to the AMR-100 receiver through
its ‘html’ interface – see the HTML INTERFACE section) – Remember 1 and 2 digit
subnet addresses have leading 0’s (.002. for .2. and .030. for .30).
1. Press [ENTER] – First digit is selected
2. Press [UP] or [DOWN] to change the digit to the desired value
3. Press [ENTER] when have the number you want (it will move to the next digit)
4. Press [UP] or [DOWN] to select next digit
5. Press [BACK] to go back to the previous digit to correct it, if necessary
6. Do this for all 12 digits, then press [ENTER] to save and return to the IP Address
submenu
*Port1: 23456 (This should not be changed unless instructed to do so by support personnel. If
you change this port number, your receiver will not accept commands through the ‘html’
interface – see the HTML INTERFACE section).
1. Press [ENTER] to select 2
2. Press [UP] or [DOWN] to change the digit to the desired value
3. Press [ENTER] to move to the next one
4. Press [BACK] to return to a previous digit to correct it
5. Press [ENTER] to go to each digit. When you press [ENTER] at the last digit, it will
save your new port number and return to the IP Address submenu
*Web Port: 80 (Normally, this does not need to be changed..) If you have multiple web
access pages at your location, you may need to change this. You change this port number
through ‘html’ interface – see the HTML INTERFACE section.
1. Press [ENTER] to select 0 – the display will change to 00080
2. Press [UP] or [DOWN] to change the digit to the desired value
3. Press [ENTER] to move to the next one
4. Press [BACK] to return to a previous digit to correct it
5. Press [ENTER] to go to each digit. When you press [ENTER] at the last digit, it will
save your new port number and return to the IP Address submenu.
6. To change the port to 8080
a. Press [ENTER] at the first 0 to move to the second 0.
b. Press [UP] to change the number to 8 – the display will read 08080
a. Press [BACK] to save the setting
Rev. 36 – Firmware version 1.61 32
©
2008