Specifications

Settings Menu
IP Address Submenu
MAC XXXXXXXXXXXX (unique to each receiver and cannot
be changed)
*Alarm: ON (default – assigned to Relay #6)
The alarm closes on the following conditions:
1. Loss of Ethernet connectivity to the network
2. Loss of connection the server
To change the setting, follow this procedure.
1. Press [ENTER] – ON is selected
2. Press [ENTER] to change it to OFF
3. Press [BACK] to return to the IP Address submenu
If you are not going to connect your receiver to your internal
network or to the Internet, turn the alarm setting to OFF.
*DHCP: YES
1. Press [ENTER] – YES is selected
2. Press [ENTER] to change to NO
3. Press [BACK] to return to the IP Address submenu
*IP Addr: XXX.XXX.XXX.XXX (See IP ADDRESS
CHANGE section) – Remember 1 and 2 digit subnet
addresses have leading 0’s (.002. for .2. and .030. for .30).
If you use a manual IP address (DHCP = No), you must
enter a subnet mask and default gateway to be able to
exit the menu.
1. Press [ENTER] – first digit is selected
2. Press [UP] or [DOWN] to change the digit to the desired
value
3. Press [ENTER] when have the number you want (it will move to the next digit)
4. Press [UP] or [DOWN] to select next digit
5. Press [BACK] to go back to the previous digit to correct it, if necessary
6. Do this for all 12 digits, then press [ENTER] to save and return to the IP Address
submenu
*Gateway: 192.168.1.1 (This is your network’s Internet gateway and provided by your
network administrator. This number is for illustration purposes only.) – Remember 1 and
2 digit subnet addresses have leading 0’s (.002. for .2. and .030. for .30).
1. Press [ENTER] – First digit is selected
2. Press [UP] or [DOWN] to change the digit to the desired value
3. Press [ENTER] when have the number you want (it will move to the next digit)
4. Press [UP] or [DOWN] to select next digit
5. Press [BACK] to go back to the previous digit to correct it, if necessary
6. Do this for all 12 digits, then press [ENTER] to save and return to the IP Address
submenu
Rev. 36 – Firmware version 1.61 29
©
2008
Web Port
Cmd Port
Cmd Addr
Port4
Server4
Port3
Server3
MAC
Alarm
DHCP
IP Addr
Gateway
Netmask
Server1
Port1
Server2
Port2
IP Addr