Specifications

If you have more than one Wegener receiver connected to your satellite antenna but have no
available splitter ports you may either (1), attach the DC Block to the AMR-100 receiver and
then install a splitter with more unused ports (not provided) or (2), pick a Wegener Unity 4000®
receiver to which you’d like to attach the provided 2 port splitter. Case (1) is the preferred
method, but if you have a unique situation or if you must install using case (2), please call AMB-
OS technical support for a consultation (877-AmbOS2U or 877-262-6728).
Rev. 36 – Firmware version 1.61 19
©
2008
WARNING
If you have only one Wegener Unity 4000® receiver and it supplies the DC power
to the LNB, the newly-added AMR-100 must have the DC Block installed on it!
RF from
a multiple
splitter
RF from
a multiple
splitter
RF from a
multiple
splitter
DC Block
DC Pass
DC Pass
1
Connect the DC
block to the
AMR-100
Connect the RF to
the splitter
AMR-100
Connect the RG-6
cables to the outputs of
the splitter
Out
In
Out
Out
In
Out
DC Block
Connect one RG-6 cable from the
DC pass port of the splitter to the
Wegener Unity 4000
Wegener
Unity 4000
Disconnect the
RF from the
Current Receiver
Wegener
Unity 4000
2
3
4
AMR-100
5
DC Pass
Out
In
Out
RF from a
multiple
splitter
Connect the other RG-6
cable to the other port on the
splitter and to the DC block
on the input on the AMR-100