Specifications

RF with 1 Wegener Unity 4000
®
Receiver
1. Install the provided DC Block on the AMR-100 receiver’s RF connector.
2. Disconnect the RF antenna cable from the Wegener Unity 4000® receiver.
3. Attach the input side (marked IN) of the splitter to the antenna cable that was
disconnected from the Wegener Unity 4000® receiver.
4. Connect one of the supplied RG-6 cables to the power-pass output port of the splitter
(marked OUT and has a diagonal line pointing to the input); connect the other provided
RG-6 cable to the remaining output marked OUT) of the splitter
5. Take the RG-6 cable connected to the DC pass output of the splitter and connect it to the
input of the Wegener Unity 4000® receiver, being careful not to short the center
conductor of the cable to the shield. Then connect the other RG-6 cable to the DC Block
(previously installed on the RF connector of the AMR-100 receiver).on the RF connector
of the AMR-100 receiver).
If you want the AMR-100 to provide power to the LNB, merely install the DC Block on the
Wegener receiver and swap the RG-6 cables coming from the splitter. Remember that in order
for a receiver to power the LNB through the supplied splitter it must be connected to the power
pass port (see #3 above). It does not matter which one supplies power, but the unit that does
not supply DC power needs to have the DC Block installed.
Rev. 36 – Firmware version 1.61 17
©
2008
RF from
antenna
DC Pass
RF from
antenna
DC Block
DC Pass
DC Pass
1
RF from
antenna
Connect the DC
block to the
AMR-100
Connect the RF to
the splitter
AMR-100
Connect the RG-6
cables to the outputs of
the splitter
Out
In
Out
Out
In
Out
DC Block
Connect one RG-6 cable from the
DC pass port of the splitter to the
Wegener Unity 4000
Wegener
Unity 4000
RF from
antenna
Disconnect the
RF from the
Current Receiver
Wegener
Unity 4000
2
3
4
AMR-100
5
Connect the other RG-6
cable to the other port on
the splitter and to the DC
block on the input on the
AMR-100
Out
In
Out