Specifications

INSTALLATION
RF
The following are provided to connect the AMR-100 to your satellite antenna.
1 – RF Splitter
1 – DC Block
2 – RG-6 cables
The AMR-100 uses the same satellite and transponder as your existing Wegener Unity 4000®
receiver(s). If your station has only one Wegener receiver connected to your satellite antenna, the
supplied splitter and cables can be used to connect RF to both receivers.
To connect your AMR-100 to RF if you have more than one Wegener receiver connected to your
satellite antenna or if you are powering your antenna’s LNB from an outboard power supply,
refer to the instructions in “RF with multiple receivers.” If the DC power to drive your
antenna’s LNB comes from your Wegener Unity 4000®, you can continue to have it supply
power, but you need to install the supplied 2 port splitter following instructions below.
Rev. 36 – Firmware version 1.61 16
©
2008
WARNING
Do not short the center lead of the RF cable to the shield or you may damage the
receiver.