Specifications

Internal Clock
The internal clock is incredibly accurate because it is set by the GPS time standard at the
uplink facility. It automatically adjusts for the new Daylight Saving Time rules that went into
effect in 2007, with Daylight Saving Time beginning on the second Sunday in March and
ending on the first Sunday in November. The local time zone can also be set.
Because the clock is accurate, relay #5 can be used to keep your local clocks in sync. The
time sync (see CLOCK INTERVAL section) can be set for any minute and second.
Resetting the receiver to default settings
At times it may be necessary to reset your receiver to the factory settings. If you change the
display contrast setting (see LCD SETTINGS section) and make the display unreadable, you
must reset the receiver.
1. Unplug the receiver
2. Hold [ENTER] as you plug in the receiver
3. Release the [ENTER] after the splash screen becomes visible
This will not change your IP settings.
Dish Alignment
The AMR-100 has an option to assist in aligning your dish (see DISH ALIGNMENT
section). The system shows a number that corresponds to the strength of the carrier. With no
carrier detected the display says:
Align: 80(No Lock)
When the proper signal is detected the display changes to:
Align: Symlock 11.52
As the alignment gets closer, the number will increase and a Symlock of around 11 is very
good.
Rev. 36 – Firmware version 1.61 13
©
2008